BrainFPV Radix and Hobbywing XRotor 60A 4 in 1 combo stack

Regular price $124.98

Shipping calculated at checkout.

BrainFPV Radix and Hobbywing XRotor 60A 4 in 1 combo stack.

 

BrainFPV Radix FC:

Features

  • Full-graphics capable OSD with horizon, gyro spectrograph, RC stick display and more.
  • Flexible design means easy builds with a stackable form factor with Radix PDB or Hobbywing 4-in-1 ESC
  • Fastest STM32 F4 processor at 180MHz
  • BMI160 Bosch Gyro
  • BMP280 Barometer
  • MicroSD slot for logging enthusiasts
  • 6 motor outputs with support for DHSOT (150/300/600/1200) and OneShot
  • Four UARTS = more ports the better! Two of them feature signal inverters for S.Bus and SmartPort, allowing for a flawless setup!
  • Engineered and tested in the USA

Specifications

  • Processor: STM32F446RET6, Coretx-M4, 32bit, 180MHz, 128kB RAM, 512kB Flash.
  • IMU: Bosch Sensortec BMI160 running at 3.2kHz, connected using SPI.
  • Baro: Bosch Sensortec BMP280 connected using SPI.
  • OSD: Full-graphic, PAL/NTSC auto detect, adjustable black and white levels. Full Betaflight OSD support with extra graphical features.
  • BEC: 5V, 2A with Radix PDB
  • Memory: MicroSD card slot for logging.
  • Motor Outputs: 6 outputs with full DSHOT (150/300/600/1200) and OneShot support.
  • Receiver Support: PPM, S.Bus (inverter built-in), DSM, HoTT, SRXL, CSRF, FPort ready. 5V or 3.3V supply for a receiver.
  • Telemetry Support: FrSKY Smart Port, FrSKY Sensor Hub, HoTT Telemetry, SRXL, CSRF, FPort ready. Built-in inverter for FrSKY telemetry.
  • Serial Ports: 4 full serial ports (UARTs). UART3 and UART6 have inverters for S.Bus and SmartPort telemetry. 
  • RGB LEDs: Dedicated RGB LED output.
  • Camera Control: Dedicated output for accessing the camera menu to change camera settings.
  • IR Emitter: Dedicated output for infrared-based lap timing with multi-protocol support (I-Lap, Trackmate). Needs external IR LED and driver.
  • Buzzer Port: Dedicated port for 5V (100mA max) buzzers.
  • Analog Inputs: Voltage sensing up to 35V, current and RSSI inputs (3.3V max).
  • Power: 4.5V to 5.5V, 120mA.
  • Dimensions: 37mm x 37mm, 30.5mm hole spacing. 4.1mm holes for anti-vibration grommets.
  • Weight: 6g

Includes

  • Radix flight controller
  • Silicone anti-vibration grommets 4x
  • Cable for connecting radix FC to Hobbywing 4-in-1 ESC

SETUP GUIDE MANUAL: https://www.brainfpv.com/knowledgebase/radix-hardware-manual/

 

Hobbywing XRotor 60amp 4 in 1 ESC:

Features

  • High-performance 32-bit microprocessor with the running frequency of up to 48MHz for an excellent performance.
  • BLHeli_32 firmware is the third generation BLHeli, following base BLHeli and BLHeli-S.
  • All codes use damped light mode. Damped light does regenerative braking, causing very fast motor retardation, and inherently also does active freewheeling.
  • The code supports features to prevent sync loss. There are tunable parameters that can make the code run well even in the most demanding situations, although default settings will work excellently in normal operating environments.
  • The code supports regular 1-2ms pulse width input, as well as Oneshot125 (125-250us), Oneshot42 (41.7-83.3us) and Multishot (5-25us).
  • Dshot signaling is supported at any rate up to at least Dshot1200. The input signal is automatically detected by the ESC upon power up.
  • The code also supports a beacon functionality, where the ESC will start beeping after a given time of zero throttles. This can be very useful for finding lost crafts.
  • Onboard 10V &5V BEC, powering different accessories such as FC, VTX, Camera and LED lights and etc.

Specifications

  • LiPo Power input: 3S-6S
  • Cont.Current: 60Ax4
  • Burst Current: 80Ax4
  • BEC Output: 5V@ 0.5A 
  • Input wires: 12AWG-130mm* (Red/Black)
  • Output Wire: No wires but solder tabs
  • Connectors: (In/Out) XT60 (w/ Wires Soldered on) /no
  • Weight / Size: 15.0g / 32.7x18.4x6.2mm
  • Mounting holes: 30.5x30.5mm
  • Throttle Calibration: Supported
  • ESC Programming: BLHeliSuite32

Includes:

  • Radix flight controller
  • Silicone anti-vibration grommets 4x
  • Cable for connecting radix FC to Hobbywing 4-in-1 ESC
  • 1x XRotor 60A 4-in-1 ESC