FC SPEC
- MCU: STM32F722
- IMU: MPU6000
- USB: Type-C
- Baro: BMP280 (I2C)
- OSD: BetaFlight OSD w/ AT7456E chip
- BLE: Support, used for Flight Controller configuration
- WiFi: Support, used for data transfer, e.g firmware flashing, and Blackbox analysis.
- DJI Air Unit slot: A full DJI Air Unit JST slot onboard
- BlackBox: 16MB onboard dataflash
- Current Sensor: 1 : 10 (Scale 168)
- BetaFlight Camera Control Pad: Yes
- Power input: 3S - 6S Lipo
- 5V power output: 7 * 5V output, 6 pads and a BZ+ pad used for Buzzer, the maximum load current is 2.5A. 9V * 1, the maximum load current is 2.5A.
- 9V power output: 2 * 9V output, 1 pads and another one used for DJI slot
- 4.5V power output: 1 * 4.5V output pad
- 3.3V power output: 1 * 3.3V output pad, the maximum load current is 500mA.
- ESC signal: M1 - M4
- UART: Full UART * 5(UART1, UART2, UART3, UART5, UART6)
- ESC Telemetry UART: UART4 RX
- I2C: Used for external Magnetometer, Sonar, etc.
- LED pin: Used for WS2812 LED
- Buzzer: BZ+ and BZ- pad used for 5V Buzzer
- Boot button: Used to easy enter DFU mode
- RSSI input: RSSI input solder pad
- SmartPort: Use any TX pad of UART for the SmartPort feature.
- Support Flight Controller Firmware: BetaFlight(Default), EMUFlight
- Target name: SPEEDYBEEF7V2
- Mounting: 30.5 x 30.5mm, 4mm hole size
- Dimension: 41 x 38 x 6.9mm
- Weight: 9g
ESC SPEC
- Firmware: BLHeli32 SpeedyBee 4in1
- MCU: STM32F051
- Continuous Current: 45A * 4
- Burst Current: 55A(10S)
- ESC Protocol: DSHOT300/600/1200
- Power input: 3S - 6S LiPo
- Power output: VBAT
- Current Sensor: Support (Scale 168)
- ESC Telemetry: Support
- Mounting: 30.5 x 30.5mm, 4mm hole size
- Dimension: 41 * 45 * 6.5mm
- Weight: 12.5g
INCLUDES
- 1x SpeedyBee F7 V2 FC
- 1x SpeedyBee 45A ESC
- 1x 50V 470uF Capacitor
- 1x XT60 Cable
- 1x JST 8pin 30mm
- 1x JST 8pin 15mm
- 1x DJI 6pin 80mm
- 5x M3*30 screws
- 5x Nylon Nuts
- 5x Grommets M3*8mm
- 5x Grommets M3*6.6mm
